Introducing DWG Internationalâ„¢ Extended Vehicle Warranty





 DWG SECURE CHOICE extended Vehicle Warrenty covers vehicles that are model year 1999 or newer and have less than 125,000 miles on the odometer.  This warranty will cover your vehicle for 5 years or 7 years, your choice, for 125,000 miles plus the current mileage.


The most comprehensive warranty on the market today covers components most warranties do not even to include SEALS & Gaskets.


This warranty even has a rebate if you do not use it!!!!

  The warranty covers:


 Engine & transmission -  all internal components of the engine that require lubrication.


Cooling system - Engine cooling fan and motor, water pump and fan clutch.


Air Conditioning System - condenser, compressor, evaporator, expansion valve and blower motor. Also covered if required in connection with the repair of a listed AC Covered Component: accumulator/receiver dryer and orfice tube.


Fuel System - fuel delivery system, fuel injection pump and metal fule delivery lines


Electrical - Alternator, voltage regulator, starter motor & solenoid, ignition switch, front and rear wiper motor and switch, washer pump & switch, headlamp switch, turn signal switch, rear defogger switch, heater/AC blower speed switch and window motor & switch, power door lock actuator.


4 X 4 Transfer Case - all internal components of the transfer case that require lubrication for operation.


Seals & Gaskets - coverage for failed seals and gaskets for covered components


Mechanical breakdown - coverage for components that have failed due to wear in excess of manufaturer's specified tolorances and faulty workmanshp or defect.


NO DEDUCTABLE ON ANY REPAIR.


Plus you receive


Towing & Rental Car benefit.  It is transferable if you sell your vehicle, nationwide coverage.


email me at: dwgken@aol.com or call me at 210 887 8827 for further information with no high pressure sales hassle,


 


 


 


 

Click to order

Ken Rodd
cell 210 887 8827
dwgken@aol.com


Distributor Pin #
163121
Other Personal Contact Info:

Ken Rodd


7009 S IH-35


Austin, TX 78744


210 887 8827


dwgken@aol.com





This site is operated by and belongs to an Independent DWG International ™ Distributor. This site is not the official DWG International ™ or DRI WASH 'n GUARD ® corporate home page.